SALT PROCESSING EQUIPMENT
Thermoblock Air Heater
Controlled heating and directional plates distribute heat through the drying system, limiting temperature variations and supporting uniform processing conditions.
Discuss this equipment
PROSALT · Salt Drying Plant
How it works
Controlled heating and directional plates distribute heat through the drying system, limiting temperature variations and supporting uniform processing conditions.
Its place in the process
The thermoblock supplies heated process air to the drying system. Its thermal duty is established from the salt moisture load and airflow, with fuel availability and plant controls considered in the overall heat balance.
Explore the complete plant ↗Engineering inputs
Specify the right configuration
Equipment selection starts with your material, the required product and the available site conditions. Share the operating range and layout with PROSALT so the interfaces, dimensions and final specification can be defined for your project.
Required drying air temperature and flow
Moisture removal duty and available energy source
Temperature control, ductwork and service access
Final materials, dimensions, drive power and operating targets are defined in the project specification. Product images illustrate the equipment family.
Technical reference
Equipment for a 50 t/h plant
These dimensions and specifications refer to equipment used in a 50 t/h plant. Every PROSALT plant is custom engineered; dimensions, materials, motor power and quantities may vary with the project. Request the current catalogue for up-to-date technical specifications.
| Parameter | Reference specification |
|---|---|
| Reference plant capacity | 50 t/h |
| Outer body diameter | Ø1900 mm |
| Inner body diameter | Ø940 mm |
| Outer body plate | 3 mm carbon steel |
| Inner body material | AISI 310 stainless steel (heat resistant) |
| Height | 2 750 mm |
| Length | 4 000 mm |
| Quantity in the reference plant | 2 pcs |
Equipment questions
How is the heater capacity selected?
It follows the process heat balance rather than salt throughput alone. Feed moisture, target moisture, air conditions and operating hours are needed to establish the duty.
Can this equipment be integrated into an existing salt plant?
A retrofit is assessed from the existing process flow, material analysis, available dimensions and utility connections. The upstream and downstream equipment must be reviewed together before the scope is agreed.
YOUR NEXT CHAPTER
A better process starts with a conversation.
A new facility or a single piece of equipment. Tell us what you have in mind.
Talk to our team